Co Mill is used for Dry and Wet Milling / Size reduction of wide range of products. It’s suitable for standalone as well as online milling.
Benefits & Highlights
Low speed design allowing for inherently gentle action on the product resulting in optimum particle granularity, low heat, low noise, minimal fines and consistent, high quality end product can be used on heat sensitive products, high capacities, fully customizable to many different application and process stream
Advantages as compared to other Milling Equipment
The output of co mill is near to the size of sieve used approx. 80%-90%, whereas in multi mill it is 1/3 of the sieve used
The fines generated are on a lower side as compare to other mills
Heat generation in co mill is comparatively very low as it works on forced pressure
Other mills have more of dusting as compared to co mill
Output of co mill is more than any other mills
1HP, 3HP, 5HP, 7.5HP, 10HP, 12.5HP Model
Granulation of dry powders for tablet manufacture bulk density fine tuning sizing. Uniform sizing of wet granulation in tablet manufacturing.
Lump free homogeneous blending to precise-size requirements.
Reducing difficult, sticky, heat-sensitive agglomerates into pieces, crumbs or powders of uniform size, continuously without excessive heat buildup or screen blockage.
Working Principle of Co Mills
The Co Mill is used for a wide range of products and applications. It can be used for mixing and dispersing, size reducing, separating and bulk density adjustment. The typical particle size distribution (PSD) is tightly contained with the 1 mm Sieve to 0.25 mm Sieve range (18 mesh to 120 mesh), depending on the screen and impeller choices. Traditional milling technologies do not have the same control over the PSD resulting in more fines & thus causing more of dust, whereas, in a Co Mill, the fines generated are much lesser & no dusting of materials, thus, giving a better and efficient milling results. We are manufacturer, supplier and exporter of co mills according to ISI guidelines and user’s requirements since 1990 from Mumbai to India and all over the world.
Advantages of Co Mills :
The output in co mill is very near to the size of the sieve used approx 80% -90% where as in multi mill it is 1/3 of the sieve used.
The fines generated are on a lower side as compared to other mills.
Heat generation in co mill is comparatively very low as it works as forced pressure.
Other mills have more of dusting as compared to co mill. Drive element are reduced in co mill as it is direct driven.
Output in co mill is more than in other mills.
Design is flexible as per your requirement.
Design is suitable for dry as well as wet milling.